#RIVAL MEAT SLICER BLADE SHARPENING MANUAL#

Step 6: Assemble the slicer now and apply the lubricant on the food tube slide rod.

A aerosol spray is preferred here since the sharpening stone assembly is small and it will be hard to apply the gel on the shafts located in narrow spaces.

Step 5: Use the aerosol lubricant spray to apply the lubricant on the main shaft as well as the shafts of the sharpening stones.

Step 4: Next, to apply lubricant to the sharpening stones, remove the sharpening stone assembly by undoing the release knob.

Step 3: Apply the lubricant on the Guide Road using your fingers and slide the Slider up and down a few times to spread the lubricant properly on the Guide Rod.

Step 2: Tilt up the slicer on the side of the blade to expose the exposed Guide Rod, placed below the slicer.

Step 1: Remove the food tube by releasing the knob underneath it.

Vegetable oil gums up the slicer parts and ends up damaging the slicer in the long run. I have received a lot of queries from readers on whether they can use vegetable oil for this and I highly discourage it. Never ever use vegetable oil for lubricating your meat slicer. Lubrication should always be done with a food grade lubricating agent which comes in both aerosol form or gel form ( Petro-gel). Lubrication would also ensure that the blades rotate with the least resistance thereby improving cutting efficiency and reducing power consumption. Regularly lubricating your meat slicer at home or at deli would ensure you do not encounter the problem of the slicer not spinning.

#RIVAL MEAT SLICER BLADE SHARPENING MANUAL#

If you follow the manual that came with your slicer, it should not be difficult for you to remove the blade and get rid of any residual food buildup or debris using glass cleaner or cleaning alcohol. Make sure that the auto-speed position sensor vane is clean. If your slicer refuses to work properly, then it might need some thorough cleaning. Prolonged use without cleaning can lead to food residue clogging the meat slicer. In such a case, the motor needs to be repaired or replaced, depending on the extent of wear-and-tear.Ĭheck if the Meat Slicer required cleaning: It is also possible that the teeth of the gears in the motor are damaged. If your meat slicer has been noisy lately, it is a proof that the motor is overworked. If you are sure that the device is receiving power properly, then it is time to look at the motor, which is responsible for making the blades spin. In this case, you’ll have to either repair the cord or switch or they have to be replaced. It is even possible that the power switch of your device is not working correctly.

It is possible that the power cord has been cut, either by mice or by some other sharp instrumets, so the device is not receiving electricity.

Investigate the power cord or the switch for defects: Make sure that the power at the outlet is on, and the power cord is plugged in properly. Have you plugged the cord properly or it is loosely connected? Have you turned on the switch? If your meat slicer doesn’t spin, check for the simplest of all problems – whether the device is getting power or not. It is time to try and understand the reasons. There can be many reasons why your meat slicer has stopped spinning. 4 Conclusion What to do if the Meat Slicer is not spinning? Identify the cause of the problem.1 What to do if the Meat Slicer is not spinning?.

Rival meat slicer blade sharpening